Firmware updates

Information about the firmware update for the GY-HM600E.

Version: V0410

 

Points of improvement in reference to the previous version

(03.29.2017)

Add [Focus Ring Conrol] menu to set priority to ring operation
Constant [present] varies at a fixed rotating angular speed regardless of the ring operation speed
Adoptive [new]  varies with variabl rotating angular speed depending on the ring operation speed

Add [SHUTTER SW] menu to set the shutter Enable/Disable to prevent erroneous operation

Fix the TC recorded with AVCHD cannot be improved into FCP correctly

Fix unusually no sound from Headphone output on 1080/60p recording

Modify the lens control to prevent unexpected zoom behavior during zoom stop

 

Warning:

This software should only be uploaded to the unit for which it is intended. If this software is uploaded to a unit other than the product it is designed for, it will render the unit inoperative.
If the software upload fails, and subsequent upload attempts prove unsuccessful, the unit may need to be returned to JVC for service.  

 

Software License Agreement
By downloading, installing, or using this software, you agree to be bound by the terms and conditions of the following license agreement. Please read this agreement carefully.

JVC grants you a limited, non-exclusive license to use the upgrade software ("Software") in binary executable form in the normal operation of the applicable JVC products. Title, ownership rights, and intellectual property rights in and to the Software remain in JVC. This license is personal to you and you may make copies of the software only for your personal use. You agree that this license agreement does not need to be signed for it to take effect.

The software is provided on an "as is" basis without warranty of any kind -- either expressed or implied -- including, without limitation, any implied warranties of merchantability or fitness for a particular purpose. JVC does not warrant the performance of the software or that the software will meet your requirements or operate error free.

 

Procedure

Attach both AC Adapter and Battery when updating.

Disconnect/Remove USB cable, Video cables (HDMI, SDI, A/V, etc), other cables except AC Adapter.

Do NOT power off during updating

It takes about 3 minutes for updating

After Firmware update, please go to System Menu and proceed a system reset.
This operation will be necessary for a proper update of your camcorder.

 

Please make shure you read the "Firmware Update Procedure" - GY-HM600_650_FirmwareUpdateE.pdf